Natural Gas Safety Valve (Socket)
Natural gas safety valve with a thermal device and quick connection. Available with a steel safety device (resistant up to 925 degrees), and with the brass safety device (resistant up to 650 degrees).
Also available without a thermal safety device.
Related products
-
General & Physical Tests
Hot Pressure Deformation Test Tool as per IEC 60811-508
0 out of 5(0)Hot deformation test is also called a hot pressure test is an acceptance test in order to assess high-temperature resistance of the material to deformation. Thermoplastics tend to deform under high temperatures and small damage during movement or under installation to cable, can cause a puncture or cut of insulation. This could result in the circuit break down shutting down the entire system.
According to the famous test institute of Germany, it was said that the most failing test for HO5-HO7V K cables is this test. In order to achieve a high speed of extrusion, manufacturers tend to inadvertently ignore the impact of compound degradation.SKU: n/aThis product has multiple variants. The options may be chosen on the product page -
General & Physical Tests
Multi Cell Ageing Oven (IEC & UL2556 Compliant)
0 out of 5(0)Multicell Ageing Ovens (with or Without HMI-PLC control)
Each Cell is a complete instrument in itself i.e., fitted with individual Temp. Indicating Controller, Air Flow Meter, Air temperature controller and an
Hour Meter. This enables the user to test different type of samples at desired temperature and duration, depending upon test requirement of end users
& testing authorities.
The instrument consists of the following:
• Double walled chamber with inside chamber of thick aluminum sheet. Size of the chamber is 10 cm x 30 cm
• Digital Temp. Indicating Controller with sensor. Temp. range 0-200 ± 2 o C
• Digital Flow meter for monitoring the volume of air passing through the chamber.
• Air inlet nozzle for the airline or air compressor.
• Specially Designed heaters to heat the air before it enters the cell
• Separate temperature controllers for air temperature control
• Air turbulence fan with motor to rotate at 60 RPM (Air source has to be provided by User)
• Specially designed cover to hold three to five test samples in each chamber.
• Timer System to record the total time of test.SKU: n/aThis product has multiple variants. The options may be chosen on the product page -
General & Physical Tests
Cold Bend Test | Cold Impact Test
0 out of 5(0)IEC 60811-504 describes the cold bend test method for cables under low temperatures. The cold bend test on cable is only possible upto a maximum diameter of 12.5mm. The test is mainly conclusive to understand the flexibility and strength of plastic used over cable under low temperatures.
Whereas cold impact test on cables is performed according to IEC 60811-506. This test is mainly designed to simulate the plastic’s capacity to resist mechanical shock under cold environment.Here from a certain height, mandrels of specific weight are dropped on the cable.
SKU: n/aThis product has multiple variants. The options may be chosen on the product page