Natural Gas Safety Valve (Socket)
<p class="stock in-stock"></p>
Natural gas safety valve with a thermal device and quick connection. Available with a steel safety device (resistant up to 925 degrees), and with the brass safety device (resistant up to 650 degrees).
Also available without a thermal safety device.
Related products
-
General & Physical Tests
100L High Temperature Constant Temperature Oil Bath
0 out of 5(0)100L High Temperature Constant Temperature Oil Bath is suitable for oil resistance test of plastics such as enameled wire and insulating covering. The test piece is immersed in the test oil at a predetermined temperature, and after a certain period of time tensile residual value is measured. It is in line with GB/T 2951 , GB/T 5023, GB/T 5013, UL, VDE, CSA, JIS and other standards.
SKU: n/a -
General & Physical Tests
Multi Cell Ageing Oven (IEC & UL2556 Compliant)
0 out of 5(0)Multicell Ageing Ovens (with or Without HMI-PLC control)
Each Cell is a complete instrument in itself i.e., fitted with individual Temp. Indicating Controller, Air Flow Meter, Air temperature controller and an
Hour Meter. This enables the user to test different type of samples at desired temperature and duration, depending upon test requirement of end users
& testing authorities.
The instrument consists of the following:
• Double walled chamber with inside chamber of thick aluminum sheet. Size of the chamber is 10 cm x 30 cm
• Digital Temp. Indicating Controller with sensor. Temp. range 0-200 ± 2 o C
• Digital Flow meter for monitoring the volume of air passing through the chamber.
• Air inlet nozzle for the airline or air compressor.
• Specially Designed heaters to heat the air before it enters the cell
• Separate temperature controllers for air temperature control
• Air turbulence fan with motor to rotate at 60 RPM (Air source has to be provided by User)
• Specially designed cover to hold three to five test samples in each chamber.
• Timer System to record the total time of test.SKU: n/a -
General & Physical Tests
Cold Bend Test | Cold Impact Test
0 out of 5(0)IEC 60811-504 describes the cold bend test method for cables under low temperatures. The cold bend test on cable is only possible upto a maximum diameter of 12.5mm. The test is mainly conclusive to understand the flexibility and strength of plastic used over cable under low temperatures.
Whereas cold impact test on cables is performed according to IEC 60811-506. This test is mainly designed to simulate the plastic’s capacity to resist mechanical shock under cold environment.Here from a certain height, mandrels of specific weight are dropped on the cable.
SKU: n/a