Natural Gas Safety Valve (Socket)
<p class="stock in-stock"></p>
Natural gas safety valve with a thermal device and quick connection. Available with a steel safety device (resistant up to 925 degrees), and with the brass safety device (resistant up to 650 degrees).
Also available without a thermal safety device.
Related products
-
General & Physical Tests
Hot Air Oven (With or without Air change)
0 out of 5(0)Our Ovens are sturdy, with double walled construction. Inner chamber made of
ALUMINIUM or STAINLESS-STEEL sheet. Outer chamber is made of stainless steel
or galvanized steel or mild steel sheet and are duly powder coated.
The gap between the walls is filled up with special grade glass wool for proper
insulation to avoid heat losses. Inner chamber has ribs for placing the shelves at
convenient levels. Supplied with 2 or 3 removable shelves. The oven door is mounted
on heavy hinges with a handle. Door is duly insulated .
Temp control uses Thermostat ,On/Off Control ,PID Control ,Microprocessor control
*Please specify the kind of controller and accuracy required at the time of ordering.SKU: n/a -
General & Physical Tests
Thermal Stability Test | Thermal Balance Test
0 out of 5(0)Thermal Stability Test is used for materials like wire, cable, soft PVC, plastic insulating sheath, etc. It is tested at 200 Degrees Celsius ± 0.5 Degrees Celsius. It is made according to GB/T2951.7-1997 standards.
It comes with accessories included :
- test tubes as per IEC 60811-405
- PH litmus paper
SKU: n/a -
General & Physical Tests
Horizontal Cold Chamber up to -86 deg
0 out of 5(0)Techtrivial designs and develop many ranges of cold chambers for cable and plastic compounding industry. Our range goes from -23 Degree Celsius to -86 degree Celsius where you can test not only servo cables with -15 degree Celsius operating temperature but also Arctic grade cables up to -86 degree Celsius.
SKU: n/a -
General & Physical Tests
Cold Bend Test | Cold Impact Test
0 out of 5(0)IEC 60811-504 describes the cold bend test method for cables under low temperatures. The cold bend test on cable is only possible upto a maximum diameter of 12.5mm. The test is mainly conclusive to understand the flexibility and strength of plastic used over cable under low temperatures.
Whereas cold impact test on cables is performed according to IEC 60811-506. This test is mainly designed to simulate the plastic’s capacity to resist mechanical shock under cold environment.Here from a certain height, mandrels of specific weight are dropped on the cable.
SKU: n/a